August 2010 Rig Profile

Neil Davidson
Project Rhino

http://www.mudandgutsoffroad.org

RIG:

2008 Yamaha RhinoSE

Specs and Modifications:

This project started as a 2008 Special Edition Yamaha Rhino. Over the last couple months I have been working to make this Rhino the ultimate trail machine. I am not done yet but hopefully when finished this Bike will be not only a great looking trail machine but also a great performing trail machine.

Progressive 425 Shocks

These shocks have collars for adjusting the ride height, which are easily adjusted with the tool included in the kit

Baja Designs 6" Prerunners

Manufacturers and marketers of lights for the offroad industry

QuadBoss Fender Flares

3+5 offset wheels (which makes it approximately six inches wider than stock)

RDC Leveling kit

2" Suspension Kit

Cognito Motorsports Heavy Duty Spindles

gussets at both ball joints and on the steering arm for increased strength not to mention they are constructed of forged steel for durability

KFI 4000lbs Winch

4000lbs winch with 52 foot of cable designed for the larger UTV's

MotoSport Alloys Platoon wheel and MotoGrip Tire kit

These wheels feature a wide 2+5 offset which yields an extra six inches of width to your rhino over the stock 5+2 offset.

However these wheels are offered in the stock offset if you prefer not to have the extra width, they are also offered in the twelve and fourteen inch sizing

Ricochet Skid Plates:

This kit includes a-arm skids, front skid, rear skid, main belly skid, floor board skids, a rear differential skid and new mounting hardware

Crow 4-Point Harnesses and Speed Industries Harness Bar

4-point harnesses and Speed Industries harness bar

Other Information:

Highly Recommend the Kodiak Winches CubExt By Quality Gear